|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionThis document specifies the mounting dimensions required for the interchangeability of accessories for 16 MPa (160 bar) medium series cylinders in accordance with ISO 6020 1 and for 25 MPa (250 bar) series cylinders in accordance with ISO 6022. The accessories have been designed specifically for use with cylinders manufactured in accordance with ISO 6020 1 and ISO 6022, but this does not limit their application[1]. This document covers the following accessories, identified in accordance with ISO 6099: —   AP2 — rod clevis, female thread (see Figure 1 and Table 1); —   AF3 — rod flange, circular (see Figure 2 and Table 2); —   AB4 — clevis bracket, straight (see Figure 3 and Table 3); —   AB3 — clevis bracket, in angle (see Figure 4 and Table 4); —   AT4 — trunnion bracket (see Figure 5 and Table 5); —   AA4-R — pivot pin, plain bearing (snap ring type) (see Figure 6 and Table 6); —   AA4-S — pivot pin, plain bearing (split pin type) (see Figure 7 and Table 7); —   AA6-R — pivot pin, spherical bearing (snap ring type) (see Figure 6 and Table 6); —   AA6-S — pivot pin, spherical bearing (split pin type) (see Figure 7 and Table 7); —   AP6 — rod eye spherical, female thread (see Figure 8 and Table 8); —   AP4 — rod eye plain, female thread (see Figure 9 and Table 9). These accessories are used on hydraulic cylinders for mechanically transmitting the cylinder force. The design of these accessories is based on the maximum forces resulting from the specified internal diameters of the cylinders and pressures according to ISO 3320 and ISO 2944. This document applies only to the dimensional criteria of products manufactured in conformity with this document; it does not apply to their functional characteristics.  [1]   1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2. About ISOISO, the International Organization for Standardization, brings global experts together to agree on the best way of doing things – for anything from making a product to managing a process. As one of the oldest non-governmental international organizations, ISO has enabled trade and cooperation between people and companies all over the world since 1946. The International Standards published by ISO serve to make lives easier, safer and better. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|