|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS 5911-1:2002+A2:2010 2010BS EN 1916 specifies requirements and describes test methods for precast concrete pipes and fittings, unreinforced, steel fibre and reinforced, with flexible joints and nominal sizes not exceeding DN 1750 or WN/HN 1200/1800, for which the main intended use is the conveyance of sewage, rainwater and surface water under gravity or occasionally at low head of pressure in pipelines that are generally buried. The scope includes pipes (collectively referred to as “jacking pipes”) intended to be installed by pipe jacking, microtunnelling or other trenchless technology. This part of BS 5911 specifies complementary requirements to those in BS EN 1916 for unreinforced and reinforced concrete pipes and fittings, as provided for in that European Standard, with nominal sizes not exceeding DN 1500 for circular pipes with base and WN/HN 800/1200 for egg-shaped pipes. Full requirements for reinforced concrete circular trench and jacking pipes with nominal sizes greater than DN 1750, but not exceeding DN 3000, are also specified. In addition to pipes and fittings having a circular cross-section, BS EN 1916 also covers circular pipes with base and egg-shaped pipes, neither of which are within the scope of BS 5911‑100. However, these products are now manufactured in the United Kingdom and so they have been included in this part of BS 5911. Steel fibre concrete jacking pipes are not manufactured in the United Kingdom and so are excluded from this part of BS 5911. BS EN 752 , BS EN 1295‑1 and BS EN 1610 deal with the planning, design, installation and testing of drains and sewers. The Pipe Jacking Association’s “Guide to best practice for the installation of pipe jacks and microtunnels” [3] is a source of advice on the use of jacking pipes. Contains requirements from BS 5911-100 and BS 5911-120 that could not be agreed upon for inclusion in BS EN 1916.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|