|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of 25/30500990 DC 20255. Scope of the proposed work item (max 4000 characters) This document specifies the definitions and requirements for solid-wall pipes with or without internal skin and smooth internal and external surfaces extruded from the same compound throughout the wall, fittings and the system of polyethylene (PE) piping systems to be intended for use in non-pressure underground drains and sewers for foul wastewater. NOTE 1: Products complying with this document can also be used in non-pressure underground drains and sewers for surface water. This document is applicable to: a) non-pressure drains and sewers, which are intended to be used buried underground outside the building structure; reflected in the marking of products by “U”; and b) non-pressure drains and sewers, which are intended to be used buried underground both outside (application area code “U”) and within the building structure, reflected in the marking of products by “UD”. This document specifies test methods referred to in this document and test parameters. This document is applicable to pipes and fittings with or without an integral socket. This document covers a range of pipe and fitting sizes, stiffness classes, tolerance classes and gives recommendations concerning colours. NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. In conjunction with CEN/TS 12666-2[1] it is applicable to PE pipes and fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for buried piping systems for non-pressure drains an sewers. The fittings can be manufactured by injection moulding or can be fabricated from pipes and/or mouldings. This document is applicable to PE pipes and fittings for the following types of joints: — Elastomeric ring seal joints; — Butt fused joints; — Electrofusion joints; — Mechanical joints; NOTE 3: Pipes, fittings and other components conforming to any of the plastics product standards listed in the Annex D (informative) may be used with pipes and fittings conforming to this European Standard, provided they conform to the requirements for joint dimensions given in Clause 7 and to the requirements of Clause 7 and Table 13.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|