|
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of 25/30481842 DC 2025This document specifies the requirements for the materials, design, fabrication, erection, testing and inspection of site built, vertical, cylindrical, flat bottomed, above ground, welded, steel tanks for the storage of liquids at ambient temperatures and above. It is concerned with the structural design of the basic tank structure and does not provide requirements for considering process design, operational issues, safety and firefighting facilities, in-service inspection, maintenance, or repair. This document is intended for use in conjunction with EN 1993-4-2 and so adheres the general principles and performance requirements for the structural design and serviceability limit states of those tank components. Specific requirements are addressed in EN 14015. It is applicable to: – closed-top tanks, with and without internal floating roofs; – open-top tanks, with and without floating roofs; – tanks for which: a) the design pressure is not greater than 60 mbar; b) the design internal negative pressure is not lower than 6,0 mbar; c) the design metal temperature is between –40 °C and +300 °C; d) the maximum design liquid level is not higher than the top of the cylindrical shell; e) the maximum allowable stress does not exceed 260 N/mm2. The limits of application of this document terminate at the following locations: – face of the first flange in a bolted flange connection; – first threaded joint on the pipe or coupling outside of the tank shell, roof or bottom; – first circumferential joint in a pipe not having a flange connection. This document does not apply to tanks where the product is refrigerated to maintain it as a liquid at atmospheric pressure.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|