1. Scope

1.1 This specification covers three types of drawn wire suitable for fabrication into parts for electron tubes, lamps, and other devices; and one type of rod for metal-to-glass sealing (grid wire is excepted):

1.1.1 Type 1 ACommercially pure nonsag wire (Note 2 and Note 3).

1.1.2 Type 1 BCommercially pure rod suitable for metal-to-glass sealing.

1.1.3 Type 2 AThoriated filament wire containing 1 % thoria.

1.1.4 Type 2BThoriated filament wire containing 2 % thoria.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 Types 1A and 1B are designated as UNS R07005. Type 2A is designated as UNS R07911. Type 2B is designated as UNS R07912.

1.4 The following precautionary caveat pertains only to the Chemical Analysis, Section 12 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1A dimensional measurement method for testing nonsag tungsten wire above 0.030 in. (0.76 mm) in diameter is provided in Test Method F 269.

Note 2Acceptance of nonsag wire characteristics for particular applications of size shall be by agreement between producer and consumer based on either a flashed microstructure as shown by photomicrographs, or on dimensional measurement limits determined in accordance with Test Method F 269.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

F16 Test Methods for Measuring Diameter or Thickness of Wire and Ribbon for Electronic Devices and Lamps

F204 Test Method for Surface Flaws in Tungsten Seal Rod and Wire

F205 Test Method for Measuring Diameter of Fine Wire by Weighing

F219 Test Methods of Testing Fine Round and Flat Wire for Electron Devices and Lamps

F269 Test Method for Sag of Tungsten Wire

Military Standards

Keywords

electron devices; thoriated tungsten wire; tungsten wire; UNS R07005; UNS R07911; UNS R07912; Electrical conductor wire; Electrical conductor wire--specifications; Electronic materials/applications--specifications; Glass electronic seals; Lamps; Metal electronic components/devices--specifications; Seals--electronic applications (specifications); Tungsten electrical/electronic applications; UNS R07005 (tungsten); Wire--electronic devices;

ICS Code

ICS Number Code 29.060.10 (Wires)

DOI: 10.1520/F0288-96R02

ASTM International is a member of CrossRef.