ASTM E390-01(2006)e1
Historical Standard: ASTM E390-01(2006)e1 Standard Reference Radiographs for Steel Fusion Welds
SUPERSEDED (see Active link, below)
ASTM E390
1. Scope
1.1 This standard provides reference radiographs for steel fusion welds that contain typical discontinuities with varying severity levels in different thicknesses of material. The reference radiograph films are an adjunct to this standard and must be purchased separately from ASTM International if needed.
1.2 There are three volumes of reference radiographs based on seven nominal weld thicknesses as follows:
Vol I-Set of 16 plates (81/2 by 11 in.) covering base material up to and including 1/4 in. [6.4 mm] in thickness.
Vol II-Set of 29 plates (81/2 by 11 in.) covering base material over 1/4 to and including 3 in. [6.4 to 76 mm] in thickness.
Vol III-Set of 32 plates (8 1/2 by 11 in.) covering base material over 3 to including 8 in. [76 to 203 mm] in thickness.
1.3 The values stated in inch-pound units are to be regarded as the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E94 Guide for Radiographic Examination
E1316 Terminology for Nondestructive Examinations
Keywords
discontinuities; fusion welds; gamma ray; reference radiographs; steel; X-ray: Steel welds; Welding/welds; Welding/welds (nondestructive testing); Fusion-welded materials/applications; Reference radiographs;
ICS Code
ICS Number Code 25.160.40 (Welding joints and welds)
DOI: 10.1520/E0390-01R06E01
ASTM International is a member of CrossRef.
