ASTM E2515-07
Historical Standard: ASTM E2515-07 Standard Test Method for Determination of Particulate Matter Emissions Collected by a Dilution tunnel
SUPERSEDED (see Active link, below)
ASTM E2515
1. Scope
1.1 This test method is applicable for the determination of particulate matter emissions from solid-fuel-burning appliances including woodstoves, pellet-burning appliances, factory-built fireplaces, masonry fireplaces, masonry heaters, and outdoor hydronic heaters within a laboratory environment.
1.2 Analytes will be a particulate matter (PM) with no CAS number assigned. For data quality objectives, see Appendix X1.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This test method does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
NIST Documents
NIST Monograph 175 Standard Limits of ErrorASTM Standards
D2986 Practice for Evaluation of Air Assay Media by the Monodisperse DOP (Dioctyl Phthalate) Smoke Test
E2558 Test Method for Determining Particulate Matter Emissions from Fires in Low Mass Wood-Burning Fireplaces
E2618 Test Method for Measurement of Particulate Emissions and Heating Efficiency of Outdoor Solid Fuel-Fired Hydronic Heating Appliances
E2779 Test Method for Determining Particulate Matter Emissions from Pellet Heaters
E2780 Test Method for Determining Particulate Matter Emissions from Wood Heaters
E2817 Test Method for Test Fueling Masonry Heaters
AISI Documents
AISI 316 Stainless SteelKeywords
Dilution tunnel; Emission testing; Particulate matter content; Particulate matter sampling;
ICS Code
ICS Number Code 13.040.40 (Stationary source emissions)
DOI: 10.1520/E2515-07
ASTM International is a member of CrossRef.
