ASTM D7036-04
Historical Standard: ASTM D7036-04 Standard Practice for Competence of Air Emission Testing Bodies
SUPERSEDED (see Active link, below)
ASTM D7036
1. Scope
1.1 This practice specifies the general requirements for competence to carry out sampling and analysis for air emissions tests of stationary sources. It covers testing and calibration performed using standard methods, non-standard methods and methods developed by the AETB.
1.2 This practice is applicable to all bodies engaged in air emission testing regardless of the number of personnel or the scope of testing activities. When an AETB does not undertake one or more of the activities covered by the practice such as developing test methods, the requirements of those clauses do not apply.
1.3 The notes given provide clarification of text, examples, and guidance. The notes do not contain requirements and do not form an integral part of this practice.
Note 1ISO/IEC 17025 has been considered when elaborating this practice. It is to be noted that at the time of approval of this practice ISO/IEC 17025 was under revision. Several, but not all, statements of this practice are consistent with ISO/IEC 17025:1999.
Note 2This practice is a specification for competence. It does not address accreditation or any activities specific to accreditation such as on-site inspections/audits by external assessors or proficiency testing.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Referenced Standards
ISO17025 General Requirements for the Competence of Testing and Calibration Laboratories Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.Keywords
AETB; air emissions testing; data quality; emission measurement; sampling; source testing; stack testing; stationary source testing;
ICS Code
ICS Number Code 13.040.01 (Air quality in general)
DOI: 10.1520/D7036-04
ASTM International is a member of CrossRef.
