ASTM D5179-02
Historical Standard: ASTM D5179-02 Standard Test Method for Measuring Adhesion of Organic Coatings to Plastic Substrates by Direct Tensile Testing
SUPERSEDED (see Active link, below)
ASTM D5179
1. Scope
1.1 This test method covers the laboratory determination of organic coating adhesion to plastic substrates by mounting and removing an aluminum stud from the surface of the coating and measuring the force required to break the coating/substrate bond with a tensile tester.
1.2 This test method requires that the aluminum stud be adhered directly to the surface of a coated, cured panel (Fig. 1).
1.3 This test method is used to compare the adhesion of coatings to various plastic substrates, thus allowing for a quantitative comparison of various coating/substrate combinations.
1.4 Other tensile test methods are Test Method D 4541 and ISO 4624 (but are not technically equivalent).
1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D4541 Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
Other Standard
ISO4624 Paints and Varnishes--Pull-off test for adhesion Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
adhesion; bond strength; cyanoacrylate adhesive; plastic substrate; pull-off strength; pull testing; tensile tester; Adhesion--paints/related coatings/materials; Bond strength--paints/related coatings; Cyanoacrylate adhesive; Organic coatings; Pull testing; Substrates--coating applications; Tensile properties/testing--paints/related coatings;
ICS Code
ICS Number Code 25.220.60 (Organic coatings)
DOI: 10.1520/D5179-02
ASTM International is a member of CrossRef.
