ASTM C981-05
Historical Standard: ASTM C981-05 Standard Guide for Design of Built-Up Bituminous Membrane Waterproofing Systems for Building Decks
SUPERSEDED (see Active link, below)
ASTM C981
1. Scope
1.1 This guide describes the design of fully adhered built-up bituminous membrane waterproofing systems for plaza deck and promenade construction over occupied spaces of buildings where covered by a separate wearing course.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other Documents
ACI 301 Specifications for Structural Concrete in Buildings Available from ACI International, PO Box 9094, Farmington Hills, MI 48333-9094.ASTM Standards
C33 Specification for Concrete Aggregates
C578 Specification for Rigid, Cellular Polystyrene Thermal Insulation
C717 Terminology of Building Seals and Sealants
C755 Practice for Selection of Water Vapor Retarders for Thermal Insulation
C1193 Guide for Use of Joint Sealants
C1299 Guide for Use in Selection of Liquid-Applied Sealants
C1472 Guide for Calculating Movement and Other Effects When Establishing Sealant Joint Width
D41 Specification for Asphalt Primer Used in Roofing, Dampproofing, and Waterproofing
D43 Specification for Coal Tar Primer Used in Roofing, Dampproofing, and Waterproofing
D173 Specification for Bitumen-Saturated Cotton Fabrics Used in Roofing and Waterproofing
D226 Specification for Asphalt-Saturated Organic Felt Used in Roofing and Waterproofing
D227 Specification for Coal-Tar-Saturated Organic Felt Used in Roofing and Waterproofing
D312 Specification for Asphalt Used in Roofing
D449 Specification for Asphalt Used in Dampproofing and Waterproofing
D450 Specification for Coal-Tar Pitch Used in Roofing, Dampproofing, and Waterproofing
D1079 Terminology Relating to Roofing and Waterproofing
D1327 Specification for Bitumen-Saturated Woven Burlap Fabrics Used in Roofing and Waterproofing
D1668 Specification for Glass Fabrics (Woven and Treated) for Roofing and Waterproofing
D2178 Specification for Asphalt Glass Felt Used in Roofing and Waterproofing
D2822 Specification for Asphalt Roof Cement, Asbestos-Containing
D4022 Specification for Coal Tar Roof Cement, Asbestos Containing
D4586 Specification for Asphalt Roof Cement, Asbestos-Free
D4601 Specification for Asphalt-Coated Glass Fiber Base Sheet Used in Roofing
D4990 Specification for Coal Tar Glass Felt Used in Roofing and Waterproofing
D5295 Guide for Preparation of Concrete Surfaces for Adhered (Bonded) Membrane Waterproofing Systems
D5898 Guide for Details for Adhered Sheet Waterproofing
D5957 Guide for Flood Testing Horizontal Waterproofing Installations
D6152 Specification for SEBS-Modified Mopping Asphalt Used in Roofing
D6162 Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using a Combination of Polyester and Glass Fiber Reinforcements
D6163 Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using Glass Fiber Reinforcements
D6164 Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using Polyester Reinforcements
D6451 Guide for Application of Asphalt Based Protection Board
D6622 Guide for Application of Fully Adhered Hot-Applied Reinforced Waterproofing Systems
Keywords
building decks; membrane; waterproofing ;
ICS Code
ICS Number Code 91.100.50 (Binders. Sealing materials)
DOI: 10.1520/C0981-05
ASTM International is a member of CrossRef.
