Significance and Use

The properties of refractory castables can be affected by their method of installation. This practice attempts to minimize the variables encountered during installation by pneumatic gunning.

This practice provides parameters to produce gunned specimens for use in other ASTM test methods.

This practice may be used to produce specimens for acceptance testing, service evaluation, manufacturing control, and research and development.

Differences between various kinds of equipment and the differences in procedures and operator techniques may result in significant variations in the physical properties of the gunned specimens. It is recommended that the same operator use the same equipment to produce specimens for referee testing agreed to by the involved testing parties. The specific operating parameters should be shown in the report.

Although this practice is specifically designed for refractory castables containing calcium aluminate cement, it may be used with minor modifications for gun mixes containing other bond systems.

1. Scope

1.1 This practice covers a procedure for preparing refractory castable specimens usually containing calcium aluminate cement with or without metal fibers by cold nozzle-mix gunning. Specimens prepared in accordance with this practice are intended for use in standard ASTM test methods required for evaluating gunned materials.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C401 Classification of Alumina and Alumina-Silicate Castable Refractories

C865 Practice for Firing Refractory Concrete Specimens

Keywords

gunning; rebound; predampening; refractory castable; specimens; Cold-gunning method; Gunning; Predampening; Rebound; Refractories (castable); Refractory concrete; Specimen preparation (for testing)--refractories;

ICS Code

ICS Number Code 81.080 (Refractories)

DOI: 10.1520/C0903-10

ASTM International is a member of CrossRef.

ASTM C903