eLibrary >
ISO 3547-5:2020 Plain bearings - Wrapped bushes - Part 5: Checking the outside diameter >
Expand All
TOC Search:
ISO 3547-5:2020 Plain bearings - Wrapped bushes - Part 5: Checking the outside diameter, 2020
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Symbols and units
- 5 Outside diameter, Do
- 6 Purpose of checking
- 7 Methods of checking
- 7.1 General
- 7.2 Checking method A — Measurement of outside diameter, Do
- 7.3 Checking method B — Gauging of outside diameter, Do
- 7.4 Checking method D — Measurement of outside diameter, Do > 120 mm
- 8 Selection of checking method for outside diameter
- 9 ISO 3547-2:2017, test A — Outside diameter, Do
- 9.1 Measuring equipment
- 9.2 Requirements for checking the block and the setting plug
- 9.3 Determination of correction factor, C
- 9.4 Procedure
- 9.5 Measuring errors
- 9.5.1 General
- 9.5.2 Errors due to measuring equipment
- 9.5.3 Errors due to the bush
- 9.5.4 Errors due to human factors
- 9.6 Summary of the factors relating to the measurement of the outside diameter, Do, of the bush
- 9.6.1 Checking load, Fch
- 9.6.2 Diameter of the checking block, dch,1, and of the setting plug, dch,2
- 9.6.3 Upper limiting value and lower limiting value for ∆z
- 9.6.4 Correction factor, C
- 9.6.5 Conversion of the indicated measured value, ∆z, for outside diameter
- 10 ISO 3547-2:2017, test B — Outside diameter, Do
- 10.1 Gauging equipment
- 10.2 Requirements for measuring equipment
- 10.3 Procedure
- 10.4 Measuring errors
- 11 ISO 3547-2, test D — Outside diameter, Do > 120 mm
- 11.1 Gauging equipment
- 11.2 Measuring equipment
- 11.3 Procedure
- 11.4 Measuring errors
- 12 Specifications on drawings of bushes
- 13 Specifications for control of the checking equipment
- 13.1 Gauging equipment
- 13.2 Measuring equipment
- Bibliography [Go to Page]